Notifications
Clear all
markus aurachtal
Groupe: Enregistré
A(ont) rejoint: 2020/12/06
Active Member
1
|
I checked the belt status, and the printer said: X-Axis: 260... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Crash detected and after recovering, the x Axis is shifted 0... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
I encounter just the same problem. PRUSA ABS white is extrem... Dans le forum How do I print this? (Printing help) |
il y a 4 years | |
|
upper side on top of the print bed Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
question was if there is a general offset adjustment for hea... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
Heatbed temp is 15 deg lower than what printer says Dans le forum Hardware, firmware and software help |
il y a 4 years |