Prusa3D Forum

Notifications

Clear all

markus aurachtal

Group: Registered

Joined: 2020/12/06

Active Member

	I checked the belt status, and the printer said: X-Axis: 260... In forum Hardware, firmware and software help	3 years ago
	Crash detected and after recovering, the x Axis is shifted 0... In forum Hardware, firmware and software help	3 years ago
	I encounter just the same problem. PRUSA ABS white is extrem... In forum How do I print this? (Printing help)	4 years ago
	upper side on top of the print bed In forum Hardware, firmware and software help	4 years ago
	question was if there is a general offset adjustment for hea... In forum Hardware, firmware and software help	4 years ago
	Heatbed temp is 15 deg lower than what printer says In forum Hardware, firmware and software help	4 years ago

Forum Statistics

559 Forums

62.7 K Topics

441.9 K Posts

16 Online

67.2 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed