Prusa3D Forum

Notifications

Clear all

Mark B

Groupe: Enregistré

A(ont) rejoint: 2020/02/04

Active Member

	Thanks @Neophyl for the thoughtful answer. Your suggestion o... Dans le forum PrusaSlicer	il y a 4 years
	Attached should be a zip archive with 2 different sets of Pr... Dans le forum PrusaSlicer	il y a 4 years
	Support missing on layer 2 and 3 Dans le forum PrusaSlicer	il y a 4 years
	Thanks for pointing me in what turned out to be the area tha... Dans le forum Hardware, firmware and software help	il y a 4 years
	Help, Inconsistent extrusion Dans le forum Hardware, firmware and software help	il y a 4 years
	I don't know if this is causing your issue but I had a simil... Dans le forum PrusaSlicer	il y a 4 years
	Thanks again for the help Joan, your idea solved half the pr... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Thanks for the suggestions Joan, In particular thanks for th... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Help with Collapsing Supports Dans le forum How do I print this? (Printing help)	il y a 4 years
	Thanks for a pointer in the right direction ashley3120. I ha... Dans le forum Hardware, firmware and software help	il y a 4 years
	My mini order from 6 February is on it's way to Australia wi... Dans le forum General discussion, announcements and releases	il y a 4 years

Statistiques du forum

559 Forums

63 K Sujets

443.7 K Messages

20 En-ligne

67.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé