Prusa3D Forum

Notifications

Clear all

Mark B

Skupina: Registrovaný

Přidal se: 2020/02/04

Active Member

	Thanks @Neophyl for the thoughtful answer. Your suggestion o... In forum PrusaSlicer	před 4 years
	Attached should be a zip archive with 2 different sets of Pr... In forum PrusaSlicer	před 4 years
	Support missing on layer 2 and 3 In forum PrusaSlicer	před 4 years
	Thanks for pointing me in what turned out to be the area tha... In forum Hardware, firmware and software help	před 4 years
	Help, Inconsistent extrusion In forum Hardware, firmware and software help	před 4 years
	I don't know if this is causing your issue but I had a simil... In forum PrusaSlicer	před 4 years
	Thanks again for the help Joan, your idea solved half the pr... In forum How do I print this? (Printing help)	před 4 years
	Thanks for the suggestions Joan, In particular thanks for th... In forum How do I print this? (Printing help)	před 4 years
	Help with Collapsing Supports In forum How do I print this? (Printing help)	před 4 years
	Thanks for a pointer in the right direction ashley3120. I ha... In forum Hardware, firmware and software help	před 4 years
	My mini order from 6 February is on it's way to Australia wi... In forum General discussion, announcements and releases	před 4 years

Fórum Statistiky

559 Fóra

63.1 K Témata

444 K Příspěvky

20 Online

68 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed