Notifications
Clear all
MAiello
Grupa: Zarejestrowany
Dołączył: 2023/01/27
Active Member
1
|
Yes I get this as well, on the Y axis. After reporting failu... In forum Input Shaper (MK4) |
2 years temu | |
|
After two or three successful prints I am seeing HAL I2C err... In forum Hardware, firmware and software help |
2 years temu | |
|
I saw that many parts were out of stock so I jumped on the c... In forum Hardware, firmware and software help |
3 years temu | |
|
Yes I think that is a good approach. I'm going to do a littl... In forum Hardware, firmware and software help |
3 years temu | |
|
Some updates on this: After doing some more reading, I check... In forum Hardware, firmware and software help |
3 years temu | |
|
Thanks I will take a look Best regards Mike In forum Hardware, firmware and software help |
3 years temu | |
|
Thanks I will check those both out. Where can I get parts if... In forum Hardware, firmware and software help |
3 years temu | |
|
Sudden MAX_THERMAL shutdown on MK3S+ In forum Hardware, firmware and software help |
3 years temu |