Prusa3D Forum

Notifiche

Cancella tutti

MAiello

Gruppo: Registrato

Registrato: 2023/01/27

Active Member

	Yes I get this as well, on the Y axis. After reporting failu... Nel forum Input Shaper (MK4)	2 years fa
	After two or three successful prints I am seeing HAL I2C err... Nel forum Hardware, firmware and software help	2 years fa
	I saw that many parts were out of stock so I jumped on the c... Nel forum Hardware, firmware and software help	3 years fa
	Yes I think that is a good approach. I'm going to do a littl... Nel forum Hardware, firmware and software help	3 years fa
	Some updates on this: After doing some more reading, I check... Nel forum Hardware, firmware and software help	3 years fa
	Thanks I will take a look Best regards Mike Nel forum Hardware, firmware and software help	3 years fa
	Thanks I will check those both out. Where can I get parts if... Nel forum Hardware, firmware and software help	3 years fa
	Sudden MAX_THERMAL shutdown on MK3S+ Nel forum Hardware, firmware and software help	3 years fa

Statistiche Forum

585 Forum

68.1 K Discussioni

477.2 K Post

11 Online

75.8 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso