Notifications
Clear all
MAiello
Groupe: Enregistré
A(ont) rejoint: 2023/01/27
Active Member
1
|
Yes I get this as well, on the Y axis. After reporting failu... Dans le forum Input Shaper (MK4) |
il y a 2 years | |
|
After two or three successful prints I am seeing HAL I2C err... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
I saw that many parts were out of stock so I jumped on the c... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Yes I think that is a good approach. I'm going to do a littl... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Some updates on this: After doing some more reading, I check... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Thanks I will take a look Best regards Mike Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Thanks I will check those both out. Where can I get parts if... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Sudden MAX_THERMAL shutdown on MK3S+ Dans le forum Hardware, firmware and software help |
il y a 3 years |