Avisos
Vaciar todo
MAiello
Grupo: Registrado
Registrado: 2023/01/27
Active Member
1
|
Yes I get this as well, on the Y axis. After reporting failu... En el foro Input Shaper (MK4) |
hace 2 years | |
|
After two or three successful prints I am seeing HAL I2C err... En el foro Hardware, firmware and software help |
hace 2 years | |
|
I saw that many parts were out of stock so I jumped on the c... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Yes I think that is a good approach. I'm going to do a littl... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Some updates on this: After doing some more reading, I check... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Thanks I will take a look Best regards Mike En el foro Hardware, firmware and software help |
hace 3 years | |
|
Thanks I will check those both out. Where can I get parts if... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Sudden MAX_THERMAL shutdown on MK3S+ En el foro Hardware, firmware and software help |
hace 3 years |