Prusa3D Forum

Notifications

Clear all

Leo P

Grupa: Zarejestrowany

Dołączył: 2025/02/27

Active Member

	12AWG did the trick - bed now not only doesn't pull a error,... In forum Hardware, firmware and software help	5 months temu
	Yeah, I definitely did. Using 14AWG, it was still slow - but... In forum Hardware, firmware and software help	5 months temu
	So the 18awg wire finally arrived and I immediately soldered... In forum Hardware, firmware and software help	6 months temu
	The voltage across it is 12.5 Volts. I screwed the POT in a ... In forum Hardware, firmware and software help	6 months temu
	MK2S preheat Bed Thermal Runaway error - while temperature i... In forum Hardware, firmware and software help	6 months temu

Statystyki Forum

585 Fora

68 K Tematy

476.4 K Posty

9 Online

75.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte