Notifications
Clear all
Leo P
Groupe: Enregistré
A(ont) rejoint: 2025/02/27
Active Member
1
|
12AWG did the trick - bed now not only doesn't pull a error,... Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
Yeah, I definitely did. Using 14AWG, it was still slow - but... Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
So the 18awg wire finally arrived and I immediately soldered... Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
The voltage across it is 12.5 Volts. I screwed the POT in a ... Dans le forum Hardware, firmware and software help |
il y a 8 months | |
|
MK2S preheat Bed Thermal Runaway error - while temperature i... Dans le forum Hardware, firmware and software help |
il y a 8 months |