Avisos
Vaciar todo
Leo P
Grupo: Registrado
Registrado: 2025/02/27
Active Member
1
|
12AWG did the trick - bed now not only doesn't pull a error,... En el foro Hardware, firmware and software help |
hace 7 months | |
|
Yeah, I definitely did. Using 14AWG, it was still slow - but... En el foro Hardware, firmware and software help |
hace 7 months | |
|
So the 18awg wire finally arrived and I immediately soldered... En el foro Hardware, firmware and software help |
hace 7 months | |
|
The voltage across it is 12.5 Volts. I screwed the POT in a ... En el foro Hardware, firmware and software help |
hace 8 months | |
|
MK2S preheat Bed Thermal Runaway error - while temperature i... En el foro Hardware, firmware and software help |
hace 8 months |