Prusa3D Forum

Notifiche

Cancella tutti

Leo P

Gruppo: Registrato

Registrato: 2025/02/27

Active Member

	12AWG did the trick - bed now not only doesn't pull a error,... Nel forum Hardware, firmware and software help	5 months fa
	Yeah, I definitely did. Using 14AWG, it was still slow - but... Nel forum Hardware, firmware and software help	5 months fa
	So the 18awg wire finally arrived and I immediately soldered... Nel forum Hardware, firmware and software help	6 months fa
	The voltage across it is 12.5 Volts. I screwed the POT in a ... Nel forum Hardware, firmware and software help	6 months fa
	MK2S preheat Bed Thermal Runaway error - while temperature i... Nel forum Hardware, firmware and software help	6 months fa

Statistiche Forum

585 Forum

67.9 K Discussioni

476.2 K Post

9 Online

75.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso