Prusa3D Forum

Notifications

Clear all

Leo P

Group: Registered

Joined: 2025/02/27

Active Member

	12AWG did the trick - bed now not only doesn't pull a error,... In forum Hardware, firmware and software help	5 months ago
	Yeah, I definitely did. Using 14AWG, it was still slow - but... In forum Hardware, firmware and software help	6 months ago
	So the 18awg wire finally arrived and I immediately soldered... In forum Hardware, firmware and software help	6 months ago
	The voltage across it is 12.5 Volts. I screwed the POT in a ... In forum Hardware, firmware and software help	7 months ago
	MK2S preheat Bed Thermal Runaway error - while temperature i... In forum Hardware, firmware and software help	7 months ago

Forum Statistics

585 Forums

68.2 K Topics

477.9 K Posts

10 Online

76 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed