Prusa3D Forum

Notifications

Clear all

Kameron

Grupa: Zarejestrowany

Dołączył: 2017/12/17

Active Member

	The noise is from the PWM control and exchaning the fan won'... In forum Others (Archive)	7 years temu
	I still think the instructions for extruder idler spring ten... In forum Others (Archive)	7 years temu
	I guess that is one of the reasons why the extruder ist prin... In forum Others (Archive)	7 years temu
	Have got an replacement fan from Prusa, unfortunately still ... In forum Others (Archive)	7 years temu
	I have the same problems (only with layer hights < 0.1). ... In forum Others (Archive)	7 years temu
	do you guys have the left hand fan on the right way round? t... In forum Others (Archive)	8 years temu
	Prusa have assured everyone that the motors are designed and... In forum Others (Archive)	8 years temu
	I wrote the support and they told me to lower the pressure t... In forum Others (Archive)	8 years temu
	It's possible that it is normal, but that will not mean that... In forum Others (Archive)	8 years temu
	I observe exactly the same when I try to print at 0.1 layer ... In forum Others (Archive)	8 years temu
	At which layer hight you try to print? I have the same probl... In forum Others (Archive)	8 years temu
	I placed tiny ball bearings I had laying around for 20 years... In forum Others (Archive)	8 years temu
	Contacted Prusa this morning via Chat. They told me it's eas... In forum Others (Archive)	8 years temu
	I have the same problem, received my kit for around two week... In forum Others (Archive)	8 years temu
	Same problem here. Noticed it today when I printed with PETG... In forum Others (Archive)	8 years temu

Statystyki Forum

585 Fora

68.2 K Tematy

477.9 K Posty

12 Online

76 K Członkowie

Ostatni Post: Filament spool jumps off the holder Najnowszy użytkownik:: ArtiVIVO Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte