|
Yes, I'll do that tomorrow. But I'm already afraid seeing th... En el foro Hardware, firmware and software help |
hace 2 months |
|
Here is a link to the lamp: I reduced the size bei 50%. Pri... En el foro Hardware, firmware and software help |
hace 2 months |
|
I printed the lampshade again today. It didn't work again. B... En el foro Hardware, firmware and software help |
hace 2 months |
|
Thanks for your help. I loosened the belts again. The gantry... En el foro Hardware, firmware and software help |
hace 2 months |
|
After readjusting the belt tension to 96/92Hz, I printed a c... En el foro Hardware, firmware and software help |
hace 2 months |
|
Yes, the X and Y calibrations always pass the test.
Initia... En el foro Hardware, firmware and software help |
hace 2 months |
|
I have a very similar problem. I finished my kit assembly la... En el foro Hardware, firmware and software help |
hace 2 months |
|
The noise is from the PWM control and exchaning the fan won'... En el foro Others (Archive) |
hace 8 years |
|
I still think the instructions for extruder idler spring ten... En el foro Others (Archive) |
hace 8 years |
|
I guess that is one of the reasons why the extruder ist prin... En el foro Others (Archive) |
hace 8 years |
|
Have got an replacement fan from Prusa, unfortunately still ... En el foro Others (Archive) |
hace 8 years |
|
I have the same problems (only with layer hights < 0.1). ... En el foro Others (Archive) |
hace 8 years |
|
do you guys have the left hand fan on the right way round?
t... En el foro Others (Archive) |
hace 8 years |
|
Prusa have assured everyone that the motors are designed and... En el foro Others (Archive) |
hace 8 years |
|
I wrote the support and they told me to lower the pressure t... En el foro Others (Archive) |
hace 8 years |
|
It's possible that it is normal, but that will not mean that... En el foro Others (Archive) |
hace 8 years |
|
I observe exactly the same when I try to print at 0.1 layer ... En el foro Others (Archive) |
hace 8 years |
|
At which layer hight you try to print? I have the same probl... En el foro Others (Archive) |
hace 8 years |
|
I placed tiny ball bearings I had laying around for 20 years... En el foro Others (Archive) |
hace 8 years |
