|
Are you sure this has actually been done and is not just "wo... In forum General discussion, announcements and releases |
1 month ago |
|
Yes, that's what we all would expect to find. But in most Co... In forum Hardware, firmware and software help |
1 month ago |
|
In a post on Reddit which uses that picture, Prusa is now tr... In forum General discussion, announcements and releases |
1 month ago |
|
Unfortunately that stuff can't be laser-cut since it does no... In forum General discussion, announcements and releases |
1 month ago |
|
The photo angle and blur seem very deliberate. So Prusa have... In forum General discussion, announcements and releases |
1 month ago |
|
I have been wondering too. The default values, with sixtysom... In forum Hardware, firmware and software help |
1 month ago |
|
That isn't related to INDX, right? Check out the Core One+ ... In forum General discussion, announcements and releases |
1 month ago |
|
INDX will get the same black "tank turret" hood as used with... In forum General discussion, announcements and releases |
1 month ago |
|
The 8-tool version would have limited access even in the ori... In forum General discussion, announcements and releases |
1 month ago |
|
Tommy has updated the Reddit thread which discusses the limi... In forum General discussion, announcements and releases |
1 month ago |
|
If you say so... In my experience, every time you power on t... In forum Hardware, firmware and software help |
1 month ago |
|
Yes, ok -- have you read @kachidoki's clarification in the f... In forum Hardware, firmware and software help |
1 month ago |
|
To elaborate on @kachidoki's post: "Z calibration" is a proc... In forum Hardware, firmware and software help |
1 month ago |
|
OP never stated what is meant to go into the box. I assume i... In forum General discussion, announcements and releases |
1 month ago |
|
I'm afraid Prusa are forced to operate the way they do at th... In forum General discussion, announcements and releases |
1 month ago |
|
Bondtech has just processed my refund for the INDX down-paym... In forum General discussion, announcements and releases |
1 month ago |
|
More likely than not, the person who posted was directly aff... In forum General discussion, announcements and releases |
1 month ago |
|
You've been over on the other side for a while now and it se... In forum General discussion, announcements and releases |
1 month ago |
|
And even if it does not achieve anything else, getting a dos... In forum General discussion, announcements and releases |
1 month ago |
|
Is a deviation of +- 0.2 mm actually an issue? It's easily c... In forum Hardware, firmware and software help |
1 month ago |
