Actividad
 
Avisos
Vaciar todo
Julie
Julie
Grupo: Registrado
Registrado: 2023/01/09
Active Member
1
Thanks again. I finally decided on 135° because the right re...

En el foro PrusaSlicer

hace 2 years
I stand corrected.

En el foro PrusaSlicer

hace 2 years
Prusa Slicer only creates the gcode file used for printing. ...

En el foro PrusaSlicer

hace 2 years
A little more information. I started Firefox with a new prof...

En el foro General discussion, announcements and releases

hace 2 years
Thanks! I just tried Chrome and I see it, because I know whe...

En el foro General discussion, announcements and releases

hace 2 years
Can you tell me what browser you are using and possibly incl...

En el foro General discussion, announcements and releases

hace 2 years
I also have bugs and feedback about printables.com that I am...

En el foro General discussion, announcements and releases

hace 2 years
I am using Firefox on Windows and even with add-blocking dis...

En el foro General discussion, announcements and releases

hace 2 years
Thanks. I didn't see anything about a free version so I didn...

En el foro PrusaSlicer

hace 2 years
I don't think infill angle is used for the first layer. In a...

En el foro PrusaSlicer

hace 2 years
It appears that 3D-Tool is commercial software and not free....

En el foro PrusaSlicer

hace 2 years
The reason that Prusa slicer needs a measuring to is to supp...

En el foro PrusaSlicer

hace 2 years
There should probably be a sticky post for Prusa Slicer dire...

En el foro PrusaSlicer

hace 2 years
Why does printing always start at the front right corner of ...

En el foro PrusaSlicer

hace 2 years
Thanks for the warm welcome everyone. Regarding the beep, th...

En el foro Assembly and first prints troubleshooting

hace 2 years
This was fantastic compared to the built-in adjustment print...

En el foro Assembly and first prints troubleshooting

hace 2 years
This was fantastic to see. I was so confused when my lowest ...

En el foro Assembly and first prints troubleshooting

hace 2 years
Compartir: