Aktywność
 
Notifications
Clear all
jsw
jsw
Grupa: Zarejestrowany
Dołączył: 2020/02/20
Famed Member
Actually, I prefer the 3x3 squares pattern rather than the s...

In forum Assembly and first prints troubleshooting

2 years temu
Thanks. I just added a few, including yours. If you have ...

In forum General discussion, announcements and releases

2 years temu
I'm glad it worked out! Usually those are not as bad as the...

In forum General discussion, announcements and releases

2 years temu
I haven't checked the stats for some time, but on the I3 I c...

In forum General discussion, announcements and releases

2 years temu
The Blob Of Doom! Usually they look worse than they are. Fir...

In forum General discussion, announcements and releases

2 years temu
Yeah, the second one is definitely not squished enough. If t...

In forum General discussion, announcements and releases

2 years temu
Same here. I would suggest drying the spool in a warm electr...

In forum General discussion, announcements and releases

2 years temu
Ok, Doctor, here's the Big Burning Question. On those 'origi...

In forum General discussion, announcements and releases

2 years temu
I'm not really sure what you mean or what you're asking. Fro...

In forum General discussion, announcements and releases

2 years temu
Yes, the printer most definitely heats the enclosure (I have...

In forum General discussion, announcements and releases

2 years temu
According to Netcraft, forum.prusa3d.com is most likely usin...

In forum PrusaSlicer

2 years temu
Actually, many of us may have had subclinical infections tha...

In forum Coronavirus (COVID-19)

2 years temu
I will say it flat out. Thank you for your service! Good jo...

In forum Coronavirus (COVID-19)

2 years temu
The studies clearly show that those who used masks during th...

In forum Coronavirus (COVID-19)

2 years temu
I definitely take it seriously, not from a political ideolog...

In forum Coronavirus (COVID-19)

2 years temu
Sorry I misunderstood. I don't use any remote software on th...

In forum Hardware, firmware and software help

2 years temu
That is there to prevent the printer from remaining hot with...

In forum Hardware, firmware and software help

2 years temu
You might wanna post a photo and/or your model file.

In forum General discussion, announcements and releases

2 years temu
That 'endless scroll' type of thing is very trendy, and yes,...

In forum General discussion, announcements and releases

2 years temu
There is not any need to drop anything. This is not a state...

In forum PrusaSlicer

2 years temu
Strona 22 / 154
Share: