Prusa3D Forum

Notifications

Clear all

Jon

Grupa: Zarejestrowany

Dołączył: 2019/09/27

Active Member

	@just3d Turned the z nut the correct orientation, recalibrat... In forum Hardware, firmware and software help	6 years temu
	@bobstro Thanks - strange it started happening recently as w... In forum Hardware, firmware and software help	6 years temu
	Looks like it's just the left side that is upside down - i s... In forum Hardware, firmware and software help	6 years temu
	Been that way since I built the printer back in September, a... In forum Hardware, firmware and software help	6 years temu
	Strange hops on bed leveling, just started recently In forum Hardware, firmware and software help	6 years temu
	@robert-rmm200 I've used their translucent PLA before in a f... In forum How do I print this? (Printing help)	6 years temu
	Tried a water/dish soap before the previous one, no change. ... In forum How do I print this? (Printing help)	6 years temu
	Help with warping on lithophanes In forum How do I print this? (Printing help)	6 years temu

Statystyki Forum

585 Fora

67.9 K Tematy

476.1 K Posty

12 Online

75.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte