Avisos
Vaciar todo
Jon
Grupo: Registrado
Registrado: 2019/09/27
Active Member
1
|
@just3d Turned the z nut the correct orientation, recalibrat... En el foro Hardware, firmware and software help |
hace 6 years | |
|
@bobstro Thanks - strange it started happening recently as w... En el foro Hardware, firmware and software help |
hace 6 years | |
|
Looks like it's just the left side that is upside down - i s... En el foro Hardware, firmware and software help |
hace 6 years | |
|
Been that way since I built the printer back in September, a... En el foro Hardware, firmware and software help |
hace 6 years | |
|
Strange hops on bed leveling, just started recently En el foro Hardware, firmware and software help |
hace 6 years | |
|
@robert-rmm200 I've used their translucent PLA before in a f... En el foro How do I print this? (Printing help) |
hace 6 years | |
|
Tried a water/dish soap before the previous one, no change. ... En el foro How do I print this? (Printing help) |
hace 6 years | |
|
Help with warping on lithophanes En el foro How do I print this? (Printing help) |
hace 6 years |