Prusa3D Forum

Notifications

Clear all

Jon

Skupina: Registrovaný

Přidal se: 2019/09/27

Active Member

	@just3d Turned the z nut the correct orientation, recalibrat... In forum Hardware, firmware and software help	před 6 years
	@bobstro Thanks - strange it started happening recently as w... In forum Hardware, firmware and software help	před 6 years
	Looks like it's just the left side that is upside down - i s... In forum Hardware, firmware and software help	před 6 years
	Been that way since I built the printer back in September, a... In forum Hardware, firmware and software help	před 6 years
	Strange hops on bed leveling, just started recently In forum Hardware, firmware and software help	před 6 years
	@robert-rmm200 I've used their translucent PLA before in a f... In forum How do I print this? (Printing help)	před 6 years
	Tried a water/dish soap before the previous one, no change. ... In forum How do I print this? (Printing help)	před 6 years
	Help with warping on lithophanes In forum How do I print this? (Printing help)	před 6 years

Fórum Statistiky

585 Fóra

67.9 K Témata

476.1 K Příspěvky

13 Online

75.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed