Prusa3D Forum

Notifiche

Cancella tutti

Jon

Gruppo: Registrato

Registrato: 2019/09/27

Active Member

	@just3d Turned the z nut the correct orientation, recalibrat... Nel forum Hardware, firmware and software help	5 years fa
	@bobstro Thanks - strange it started happening recently as w... Nel forum Hardware, firmware and software help	5 years fa
	Looks like it's just the left side that is upside down - i s... Nel forum Hardware, firmware and software help	5 years fa
	Been that way since I built the printer back in September, a... Nel forum Hardware, firmware and software help	5 years fa
	Strange hops on bed leveling, just started recently Nel forum Hardware, firmware and software help	5 years fa
	@robert-rmm200 I've used their translucent PLA before in a f... Nel forum How do I print this? (Printing help)	5 years fa
	Tried a water/dish soap before the previous one, no change. ... Nel forum How do I print this? (Printing help)	5 years fa
	Help with warping on lithophanes Nel forum How do I print this? (Printing help)	5 years fa

Statistiche Forum

566 Forum

63.1 K Discussioni

444.1 K Post

20 Online

68.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso