Notifications
Clear all
Jeffrey Benson
Jeffrey Benson
Skupina: Registrovaný
Přidal se: 2023/03/17
Eminent Member
2
I gave up and went back to using Overture Easy Nylon, which ...

In forum How do I print this? (Printing help)

před 6 months
The enclosure sits around 100°f just from the bed and hotene...

In forum How do I print this? (Printing help)

před 6 months
For some reason my model isn't uploading

In forum How do I print this? (Printing help)

před 7 months
Trouble printing nylon on a petg raft

In forum How do I print this? (Printing help)

před 7 months
Will carbon or glass fibers in nylon printed pulleys destroy...

In forum General discussion, announcements and releases

před 7 months
Found a tiny amount of frayed ground wire on the fan bridgin...

In forum Hardware, firmware and software help

před 1 year
I just started reconnecting stuff until it failed. Parts fa...

In forum Hardware, firmware and software help

před 1 year
Started disconnecting wires and checking power as I go, even...

In forum Hardware, firmware and software help

před 1 year
After replacement hotend kit install, squares on screen, can...

In forum Hardware, firmware and software help

před 1 year
I'm pretty sure the default max fan speed was too low. I di...

In forum How do I print this? (Printing help)

před 2 years
My max fan speed was set to 50%, which is the default. I in...

In forum How do I print this? (Printing help)

před 2 years
I'm doing some test prints of just that little block in 2.6 ...

In forum How do I print this? (Printing help)

před 2 years
Brand new

In forum How do I print this? (Printing help)

před 2 years
Cruddy Edges (Galaxy Black PETG)

In forum How do I print this? (Printing help)

před 2 years
That's where it fails. I think it has something to do with ...

In forum Hardware, firmware and software help

před 2 years
No ideas. I didn't even make it to the flash screen on the ...

In forum Hardware, firmware and software help

před 2 years
Firmware update failure (com port)

In forum Hardware, firmware and software help

před 2 years
It was already under "Prusalink and Connect". You said it w...

In forum PrusaSlicer

před 2 years
Let me clarify that. I have the profiles set up in Prusa Sl...

In forum PrusaSlicer

před 2 years
How do I set up a .6mm profile and .4mm profile for the same...

In forum PrusaSlicer

před 2 years
Share: