Aktywność
 
Notifications
Clear all
Jay
Jay
Grupa: Zarejestrowany
Dołączył: 2017/10/29
Active Member
1
When I flashed the printer said it was updating, then verify...

In forum Hardware, firmware and software help

3 years temu
Looked all over the web site. No links lead to tech support....

In forum Hardware, firmware and software help

3 years temu
It is. It updated, verified, and rebooted. The control knob ...

In forum Hardware, firmware and software help

3 years temu
I downloaded 3.10.1 from here: I then got 3.9.3 from the sa...

In forum Hardware, firmware and software help

3 years temu
3.10.1 firmware broken

In forum Hardware, firmware and software help

3 years temu
@jsw The temp surprised me too.

In forum Hardware, firmware and software help

4 years temu
After double checking the specs on the filament I found the ...

In forum Hardware, firmware and software help

4 years temu
@jsw Maker Geeks Master Series PLA (Racy Red)

In forum Hardware, firmware and software help

4 years temu
Help: filament feed getting blocked on a specific print

In forum Hardware, firmware and software help

4 years temu
After an hour of swearing and getting to know the hot end wa...

In forum Hardware, firmware and software help

5 years temu
Wow. The forum software is awful. I ran out of time to edit ...

In forum Improvements (Archive)

5 years temu
Joe please pop over to the hot end factory and work on the n...

In forum Improvements (Archive)

5 years temu
feed jam

In forum Hardware, firmware and software help

5 years temu
Have you tried guitar strings or accupuncture needles to cle...

In forum Hardware, firmware and software help

5 years temu
I'm pretty sure I have it figured out. Thanks Joan!

In forum Others (Archive)

7 years temu
Thanks Joan. Great explanation. I'll get out the multimeter ...

In forum Others (Archive)

7 years temu
Heat bed failure

In forum Others (Archive)

7 years temu
Share: