Actividad
 
Avisos
Vaciar todo
Jay
Jay
Grupo: Registrado
Registrado: 2017/10/29
Active Member
1
When I flashed the printer said it was updating, then verify...

En el foro Hardware, firmware and software help

hace 3 years
Looked all over the web site. No links lead to tech support....

En el foro Hardware, firmware and software help

hace 3 years
It is. It updated, verified, and rebooted. The control knob ...

En el foro Hardware, firmware and software help

hace 3 years
I downloaded 3.10.1 from here: I then got 3.9.3 from the sa...

En el foro Hardware, firmware and software help

hace 3 years
3.10.1 firmware broken

En el foro Hardware, firmware and software help

hace 3 years
@jsw The temp surprised me too.

En el foro Hardware, firmware and software help

hace 4 years
After double checking the specs on the filament I found the ...

En el foro Hardware, firmware and software help

hace 4 years
@jsw Maker Geeks Master Series PLA (Racy Red)

En el foro Hardware, firmware and software help

hace 4 years
Help: filament feed getting blocked on a specific print

En el foro Hardware, firmware and software help

hace 4 years
After an hour of swearing and getting to know the hot end wa...

En el foro Hardware, firmware and software help

hace 5 years
Wow. The forum software is awful. I ran out of time to edit ...

En el foro Improvements (Archive)

hace 5 years
Joe please pop over to the hot end factory and work on the n...

En el foro Improvements (Archive)

hace 5 years
feed jam

En el foro Hardware, firmware and software help

hace 5 years
Have you tried guitar strings or accupuncture needles to cle...

En el foro Hardware, firmware and software help

hace 5 years
I'm pretty sure I have it figured out. Thanks Joan!

En el foro Others (Archive)

hace 7 years
Thanks Joan. Great explanation. I'll get out the multimeter ...

En el foro Others (Archive)

hace 7 years
Heat bed failure

En el foro Others (Archive)

hace 7 years
Compartir: