|
When I flashed the printer said it was updating, then verify... Nel forum Hardware, firmware and software help |
4 years fa |
|
Looked all over the web site. No links lead to tech support.... Nel forum Hardware, firmware and software help |
4 years fa |
|
It is. It updated, verified, and rebooted. The control knob ... Nel forum Hardware, firmware and software help |
4 years fa |
|
I downloaded 3.10.1 from here: I then got 3.9.3 from the sa... Nel forum Hardware, firmware and software help |
4 years fa |
|
3.10.1 firmware broken Nel forum Hardware, firmware and software help |
4 years fa |
|
@jsw The temp surprised me too. Nel forum Hardware, firmware and software help |
5 years fa |
|
After double checking the specs on the filament I found the ... Nel forum Hardware, firmware and software help |
5 years fa |
|
@jsw Maker Geeks Master Series PLA (Racy Red) Nel forum Hardware, firmware and software help |
5 years fa |
|
Help: filament feed getting blocked on a specific print Nel forum Hardware, firmware and software help |
5 years fa |
|
After an hour of swearing and getting to know the hot end wa... Nel forum Hardware, firmware and software help |
6 years fa |
|
Wow. The forum software is awful. I ran out of time to edit ... Nel forum Improvements (Archive) |
6 years fa |
|
Joe please pop over to the hot end factory and work on the n... Nel forum Improvements (Archive) |
6 years fa |
|
feed jam Nel forum Hardware, firmware and software help |
6 years fa |
|
Have you tried guitar strings or accupuncture needles to cle... Nel forum Hardware, firmware and software help |
6 years fa |
|
I'm pretty sure I have it figured out. Thanks Joan! Nel forum Others (Archive) |
8 years fa |
|
Thanks Joan. Great explanation.
I'll get out the multimeter ... Nel forum Others (Archive) |
8 years fa |
|
Heat bed failure Nel forum Others (Archive) |
8 years fa |
