|
When I flashed the printer said it was updating, then verify... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Looked all over the web site. No links lead to tech support.... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
It is. It updated, verified, and rebooted. The control knob ... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I downloaded 3.10.1 from here: I then got 3.9.3 from the sa... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
3.10.1 firmware broken Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
@jsw The temp surprised me too. Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
After double checking the specs on the filament I found the ... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
@jsw Maker Geeks Master Series PLA (Racy Red) Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Help: filament feed getting blocked on a specific print Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
After an hour of swearing and getting to know the hot end wa... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Wow. The forum software is awful. I ran out of time to edit ... Dans le forum Improvements (Archive) |
il y a 6 years |
|
Joe please pop over to the hot end factory and work on the n... Dans le forum Improvements (Archive) |
il y a 6 years |
|
feed jam Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Have you tried guitar strings or accupuncture needles to cle... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
I'm pretty sure I have it figured out. Thanks Joan! Dans le forum Others (Archive) |
il y a 8 years |
|
Thanks Joan. Great explanation.
I'll get out the multimeter ... Dans le forum Others (Archive) |
il y a 8 years |
|
Heat bed failure Dans le forum Others (Archive) |
il y a 8 years |
