Notifiche
Cancella tutti
Jason Englert
Gruppo: Registrato
Registrato: 2024/01/18
Active Member
1
|
Right. Thank you again for all of your helpful feedback! Nel forum User mods |
3 months fa | |
|
This is where I have ended up. I apologize for all of the up... Nel forum User mods |
3 months fa | |
|
I don't know if I need all the edge magnets, but I put them ... Nel forum User mods |
3 months fa | |
|
Followup. Actually the slates have a width of 7, yes, but if... Nel forum User mods |
3 months fa | |
|
I only have the Core One printer, so this is put together in... Nel forum User mods |
3 months fa | |
|
Here is my new model. There are now 17 7x7.5mm slats with ... Nel forum User mods |
3 months fa | |
|
Thank you everyone. The slats are v-shaped which should prev... Nel forum User mods |
3 months fa | |
|
Intake vent. Is a 40cm^2 intake area enough for PLA, PETG, a... Nel forum User mods |
3 months fa | |
|
I also have this problem. As I don't have the handles instal... Nel forum Assembly and troubleshooting |
2 years fa | |
|
Agreed. Please add it as an option. It should be added to th... Nel forum Hardware, firmware and software help |
2 years fa |