Prusa3D Forum

Notifications

Clear all

Jason Englert

Groupe: Enregistré

A(ont) rejoint: 2024/01/18

Active Member

	Right. Thank you again for all of your helpful feedback! Dans le forum User mods	il y a 3 months
	This is where I have ended up. I apologize for all of the up... Dans le forum User mods	il y a 3 months
	I don't know if I need all the edge magnets, but I put them ... Dans le forum User mods	il y a 3 months
	Followup. Actually the slates have a width of 7, yes, but if... Dans le forum User mods	il y a 3 months
	I only have the Core One printer, so this is put together in... Dans le forum User mods	il y a 3 months
	Here is my new model. There are now 17 7x7.5mm slats with ... Dans le forum User mods	il y a 3 months
	Thank you everyone. The slats are v-shaped which should prev... Dans le forum User mods	il y a 3 months
	Intake vent. Is a 40cm^2 intake area enough for PLA, PETG, a... Dans le forum User mods	il y a 3 months
	I also have this problem. As I don't have the handles instal... Dans le forum Assembly and troubleshooting	il y a 2 years
	Agreed. Please add it as an option. It should be added to th... Dans le forum Hardware, firmware and software help	il y a 2 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

10 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé