Prusa3D Forum

Avisos

Vaciar todo

Jason Englert

Grupo: Registrado

Registrado: 2024/01/18

Active Member

	Right. Thank you again for all of your helpful feedback! En el foro User mods	hace 3 months
	This is where I have ended up. I apologize for all of the up... En el foro User mods	hace 3 months
	I don't know if I need all the edge magnets, but I put them ... En el foro User mods	hace 3 months
	Followup. Actually the slates have a width of 7, yes, but if... En el foro User mods	hace 3 months
	I only have the Core One printer, so this is put together in... En el foro User mods	hace 3 months
	Here is my new model. There are now 17 7x7.5mm slats with ... En el foro User mods	hace 3 months
	Thank you everyone. The slats are v-shaped which should prev... En el foro User mods	hace 3 months
	Intake vent. Is a 40cm^2 intake area enough for PLA, PETG, a... En el foro User mods	hace 3 months
	I also have this problem. As I don't have the handles instal... En el foro Assembly and troubleshooting	hace 2 years
	Agreed. Please add it as an option. It should be added to th... En el foro Hardware, firmware and software help	hace 2 years

Estadísticas del Foro

585 Foros

68.2 K Temas

477.7 K Respuestas

13 En línea

75.9 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado