Prusa3D Forum

Notifications

Clear all

Jason Englert

Skupina: Registrovaný

Přidal se: 2024/01/18

Active Member

	Right. Thank you again for all of your helpful feedback! In forum User mods	před 10 months
	This is where I have ended up. I apologize for all of the up... In forum User mods	před 10 months
	I don't know if I need all the edge magnets, but I put them ... In forum User mods	před 10 months
	Followup. Actually the slates have a width of 7, yes, but if... In forum User mods	před 10 months
	I only have the Core One printer, so this is put together in... In forum User mods	před 10 months
	Here is my new model. There are now 17 7x7.5mm slats with ... In forum User mods	před 10 months
	Thank you everyone. The slats are v-shaped which should prev... In forum User mods	před 10 months
	Intake vent. Is a 40cm^2 intake area enough for PLA, PETG, a... In forum User mods	před 10 months
	I also have this problem. As I don't have the handles instal... In forum Assembly and troubleshooting	před 2 years
	Agreed. Please add it as an option. It should be added to th... In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

598 Fóra

71.4 K Témata

501 K Příspěvky

14 Online

82.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed