Avisos
Vaciar todo
James
Grupo: Registrado
Registrado: 2017/02/23
Active Member
1
|
upgraded two mk3s to latest firmware (3.10.1) and both now f... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Finally figured out the x-axis idler was way too tight and w... En el foro Prusa i3 kit (Archive) |
hace 7 years | |
|
swapping X and Y motors makes no difference. It fails in the... En el foro Prusa i3 kit (Archive) |
hace 7 years | |
|
thought it was about time I tried swapping the X and Y motor... En el foro Prusa i3 kit (Archive) |
hace 7 years | |
|
After leaving the printer alone for a couple of months I tri... En el foro Prusa i3 kit (Archive) |
hace 7 years | |
|
Thanks for the suggestions. I am running on high power. Have... En el foro Prusa i3 kit (Archive) |
hace 8 years | |
|
X-Axis stops on bed levelling En el foro Prusa i3 kit (Archive) |
hace 8 years |