Notifiche
Cancella tutti
James
Gruppo: Registrato
Registrato: 2017/02/23
Active Member
1
|
upgraded two mk3s to latest firmware (3.10.1) and both now f... Nel forum Hardware, firmware and software help |
3 years fa | |
|
Finally figured out the x-axis idler was way too tight and w... Nel forum Prusa i3 kit (Archive) |
7 years fa | |
|
swapping X and Y motors makes no difference. It fails in the... Nel forum Prusa i3 kit (Archive) |
7 years fa | |
|
thought it was about time I tried swapping the X and Y motor... Nel forum Prusa i3 kit (Archive) |
7 years fa | |
|
After leaving the printer alone for a couple of months I tri... Nel forum Prusa i3 kit (Archive) |
7 years fa | |
|
Thanks for the suggestions. I am running on high power. Have... Nel forum Prusa i3 kit (Archive) |
8 years fa | |
|
X-Axis stops on bed levelling Nel forum Prusa i3 kit (Archive) |
8 years fa |