Notifications
Clear all
James
Grupa: Zarejestrowany
Dołączył: 2017/02/23
Active Member
1
|
upgraded two mk3s to latest firmware (3.10.1) and both now f... In forum Hardware, firmware and software help |
3 years temu | |
|
Finally figured out the x-axis idler was way too tight and w... In forum Prusa i3 kit (Archive) |
7 years temu | |
|
swapping X and Y motors makes no difference. It fails in the... In forum Prusa i3 kit (Archive) |
7 years temu | |
|
thought it was about time I tried swapping the X and Y motor... In forum Prusa i3 kit (Archive) |
7 years temu | |
|
After leaving the printer alone for a couple of months I tri... In forum Prusa i3 kit (Archive) |
7 years temu | |
|
Thanks for the suggestions. I am running on high power. Have... In forum Prusa i3 kit (Archive) |
8 years temu | |
|
X-Axis stops on bed levelling In forum Prusa i3 kit (Archive) |
8 years temu |