Čeština
Fóra
Uživatelé
ImAlias
Aktivita
 
Notifications
Clear all
ImAlias
ImAlias
Skupina: Registrovaný
Přidal se: 2022/08/30
Active Member
1
Profile Aktivita
I'm not quite up to speed. I did this and it worked fine - ...

In forum PrusaSlicer

 před 3 months
Never mind - I see what I did wrong. Thanks for the help

In forum PrusaSlicer

 před 3 months
I'm sure you're right but maybe I'm missing some setting som...

In forum PrusaSlicer

 před 3 months
Why is there an option to change the Z position in the slice...

In forum PrusaSlicer

 před 3 months
Simple slicer question

In forum PrusaSlicer

 před 3 months
I got a thermal error after about 19 hours of printing. Thi...

In forum How do I print this? (Printing help)

 před 9 months
Send: N18101 G1 X85.309 Y108.021 E.01332*101 Recv: ok Send: ...

In forum Hardware, firmware and software help

 před 11 months
2 seconds after I posted that I got another M112 error.

In forum Hardware, firmware and software help

 před 11 months
Recent temperature fluctuations

In forum Hardware, firmware and software help

 před 11 months
Persistent leak

In forum Hardware, firmware and software help

 před 2 years
Can’t remove previous print image from bed.

In forum Hardware, firmware and software help

 před 2 years
Is this a clog?

In forum Hardware, firmware and software help

 před 3 years
And is there a way to see the supports in Prusa Slicer? If ...

In forum How do I print this? (Printing help)

 před 3 years
Do I need supports if I print the individual pieces?

In forum How do I print this? (Printing help)

 před 3 years
OK but are there simple instructions that say click here, ty...

In forum How do I print this? (Printing help)

 před 3 years
Is this too complicated for me?

In forum How do I print this? (Printing help)

 před 3 years
Ooops. I can't get all the nearly invisible PETG off the smo...

In forum General discussion, announcements and releases

 před 3 years
Share: