Prusa3D Forum

Notifications

Clear all

ImAlias

Groupe: Enregistré

A(ont) rejoint: 2022/08/30

Active Member

	I'm not quite up to speed. I did this and it worked fine - ... Dans le forum PrusaSlicer	il y a 3 months
	Never mind - I see what I did wrong. Thanks for the help Dans le forum PrusaSlicer	il y a 3 months
	I'm sure you're right but maybe I'm missing some setting som... Dans le forum PrusaSlicer	il y a 3 months
	Why is there an option to change the Z position in the slice... Dans le forum PrusaSlicer	il y a 3 months
	Simple slicer question Dans le forum PrusaSlicer	il y a 3 months
	I got a thermal error after about 19 hours of printing. Thi... Dans le forum How do I print this? (Printing help)	il y a 9 months
	Send: N18101 G1 X85.309 Y108.021 E.01332*101 Recv: ok Send: ... Dans le forum Hardware, firmware and software help	il y a 11 months
	2 seconds after I posted that I got another M112 error. Dans le forum Hardware, firmware and software help	il y a 11 months
	Recent temperature fluctuations Dans le forum Hardware, firmware and software help	il y a 11 months
	Persistent leak Dans le forum Hardware, firmware and software help	il y a 2 years
	Can’t remove previous print image from bed. Dans le forum Hardware, firmware and software help	il y a 2 years
	Is this a clog? Dans le forum Hardware, firmware and software help	il y a 3 years
	And is there a way to see the supports in Prusa Slicer? If ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Do I need supports if I print the individual pieces? Dans le forum How do I print this? (Printing help)	il y a 3 years
	OK but are there simple instructions that say click here, ty... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Is this too complicated for me? Dans le forum How do I print this? (Printing help)	il y a 3 years
	Ooops. I can't get all the nearly invisible PETG off the smo... Dans le forum General discussion, announcements and releases	il y a 3 years

Statistiques du forum

595 Forums

69.3 K Sujets

484.5 K Messages

15 En-ligne

78.6 K Membres

Le dernier des messages: Should I down load 6.4.0 Notre nouveau membre: frenchzed Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé