Italiano
Forum
Utenti
ImAlias
Attività
 
Notifiche
Cancella tutti
ImAlias
ImAlias
Gruppo: Registrato
Registrato: 2022/08/30
Active Member
1
Profilo Attività
I'm not quite up to speed. I did this and it worked fine - ...

Nel forum PrusaSlicer

 3 months fa
Never mind - I see what I did wrong. Thanks for the help

Nel forum PrusaSlicer

 3 months fa
I'm sure you're right but maybe I'm missing some setting som...

Nel forum PrusaSlicer

 3 months fa
Why is there an option to change the Z position in the slice...

Nel forum PrusaSlicer

 3 months fa
Simple slicer question

Nel forum PrusaSlicer

 3 months fa
I got a thermal error after about 19 hours of printing. Thi...

Nel forum How do I print this? (Printing help)

 9 months fa
Send: N18101 G1 X85.309 Y108.021 E.01332*101 Recv: ok Send: ...

Nel forum Hardware, firmware and software help

 11 months fa
2 seconds after I posted that I got another M112 error.

Nel forum Hardware, firmware and software help

 11 months fa
Recent temperature fluctuations

Nel forum Hardware, firmware and software help

 11 months fa
Persistent leak

Nel forum Hardware, firmware and software help

 2 years fa
Can’t remove previous print image from bed.

Nel forum Hardware, firmware and software help

 2 years fa
Is this a clog?

Nel forum Hardware, firmware and software help

 3 years fa
And is there a way to see the supports in Prusa Slicer? If ...

Nel forum How do I print this? (Printing help)

 3 years fa
Do I need supports if I print the individual pieces?

Nel forum How do I print this? (Printing help)

 3 years fa
OK but are there simple instructions that say click here, ty...

Nel forum How do I print this? (Printing help)

 3 years fa
Is this too complicated for me?

Nel forum How do I print this? (Printing help)

 3 years fa
Ooops. I can't get all the nearly invisible PETG off the smo...

Nel forum General discussion, announcements and releases

 3 years fa
Condividi: