Čeština
Fóra
Uživatelé
ImAlias
Aktivita
 
Notifications
Clear all
ImAlias
ImAlias
Skupina: Registrovaný
Přidal se: 2022/08/30
Active Member
1
Profile Aktivita
I'm not quite up to speed. I did this and it worked fine - ...

In forum PrusaSlicer

 před 3 weeks
Never mind - I see what I did wrong. Thanks for the help

In forum PrusaSlicer

 před 3 weeks
I'm sure you're right but maybe I'm missing some setting som...

In forum PrusaSlicer

 před 3 weeks
Why is there an option to change the Z position in the slice...

In forum PrusaSlicer

 před 4 weeks
Simple slicer question

In forum PrusaSlicer

 před 4 weeks
I got a thermal error after about 19 hours of printing. Thi...

In forum How do I print this? (Printing help)

 před 7 months
Send: N18101 G1 X85.309 Y108.021 E.01332*101 Recv: ok Send: ...

In forum Hardware, firmware and software help

 před 9 months
2 seconds after I posted that I got another M112 error.

In forum Hardware, firmware and software help

 před 9 months
Recent temperature fluctuations

In forum Hardware, firmware and software help

 před 9 months
Persistent leak

In forum Hardware, firmware and software help

 před 2 years
Can’t remove previous print image from bed.

In forum Hardware, firmware and software help

 před 2 years
Is this a clog?

In forum Hardware, firmware and software help

 před 3 years
And is there a way to see the supports in Prusa Slicer? If ...

In forum How do I print this? (Printing help)

 před 3 years
Do I need supports if I print the individual pieces?

In forum How do I print this? (Printing help)

 před 3 years
OK but are there simple instructions that say click here, ty...

In forum How do I print this? (Printing help)

 před 3 years
Is this too complicated for me?

In forum How do I print this? (Printing help)

 před 3 years
Ooops. I can't get all the nearly invisible PETG off the smo...

In forum General discussion, announcements and releases

 před 3 years
Share: