Ian Harris – Attività – Prusa3D Forum

Notifiche

Cancella tutti

Ian Harris

Gruppo: Registrato

Registrato: 2022/02/23

Eminent Member

	Disable firmware update message? Nel forum Hardware, firmware and software help	3 years fa
	Two questions, if I may. 1) If the printer already has 3.12.... Nel forum General discussion, announcements and releases	3 years fa
	Since installing v3.12.1.5686 and completing the thermal cal... Nel forum General discussion, announcements and releases	3 years fa
	3.12.1.5686 worked Nel forum Hardware, firmware and software help	3 years fa
	Well, success with v3.12.1.5686 firmware, although not quite... Nel forum General discussion, announcements and releases	3 years fa
	I would change the infill type (Gyroid maybe?), or change th... Nel forum PrusaSlicer	3 years fa
	I can understand a lot of work has gone into the v3.12 firmw... Nel forum General discussion, announcements and releases	3 years fa
	Well, tried v3.12 and guess what? "Thermal Anomaly". The pri... Nel forum General discussion, announcements and releases	3 years fa
	I have to say the reports of "Thermal Anomaly" problems don'... Nel forum General discussion, announcements and releases	3 years fa
	Would be nice to have a modifier available to block parts of... Nel forum PrusaSlicer	4 years fa
	Any new Prusament PETG colours planned? Nel forum General discussion, announcements and releases	4 years fa

Pagina 2 / 2 Precedente

Statistiche Forum

585 Forum

68.4 K Discussioni

478.9 K Post

11 Online

76.4 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso