|
Information on main screen In forum General discussion, announcements and releases |
před 3 years |
|
I would agree - a z screw cover is needed. -- Ian In forum General discussion, announcements and releases |
před 3 years |
|
Yes, eventually, it took a couple of tries with 3.12.1 , but... In forum General discussion, announcements and releases |
před 3 years |
|
I would say the thermal modelling in 3.12 is still a beta th... In forum General discussion, announcements and releases |
před 3 years |
|
Disable firmware update message? In forum Hardware, firmware and software help |
před 3 years |
|
Two questions, if I may. 1) If the printer already has 3.12.... In forum General discussion, announcements and releases |
před 3 years |
|
Since installing v3.12.1.5686 and completing the thermal cal... In forum General discussion, announcements and releases |
před 3 years |
|
3.12.1.5686 worked In forum Hardware, firmware and software help |
před 3 years |
|
Well, success with v3.12.1.5686 firmware, although not quite... In forum General discussion, announcements and releases |
před 3 years |
|
I would change the infill type (Gyroid maybe?), or change th... In forum PrusaSlicer |
před 3 years |
|
I can understand a lot of work has gone into the v3.12 firmw... In forum General discussion, announcements and releases |
před 3 years |
|
Well, tried v3.12 and guess what? "Thermal Anomaly". The pri... In forum General discussion, announcements and releases |
před 3 years |
|
I have to say the reports of "Thermal Anomaly" problems don'... In forum General discussion, announcements and releases |
před 3 years |
|
Would be nice to have a modifier available to block parts of... In forum PrusaSlicer |
před 4 years |
|
Any new Prusament PETG colours planned? In forum General discussion, announcements and releases |
před 4 years |
