Ian Harris – Activité – Prusa3D Forum

Notifications

Clear all

Ian Harris

Groupe: Enregistré

A(ont) rejoint: 2022/02/23

Eminent Member

	Disable firmware update message? Dans le forum Hardware, firmware and software help	il y a 3 years
	Two questions, if I may. 1) If the printer already has 3.12.... Dans le forum General discussion, announcements and releases	il y a 3 years
	Since installing v3.12.1.5686 and completing the thermal cal... Dans le forum General discussion, announcements and releases	il y a 3 years
	3.12.1.5686 worked Dans le forum Hardware, firmware and software help	il y a 3 years
	Well, success with v3.12.1.5686 firmware, although not quite... Dans le forum General discussion, announcements and releases	il y a 3 years
	I would change the infill type (Gyroid maybe?), or change th... Dans le forum PrusaSlicer	il y a 3 years
	I can understand a lot of work has gone into the v3.12 firmw... Dans le forum General discussion, announcements and releases	il y a 3 years
	Well, tried v3.12 and guess what? "Thermal Anomaly". The pri... Dans le forum General discussion, announcements and releases	il y a 3 years
	I have to say the reports of "Thermal Anomaly" problems don'... Dans le forum General discussion, announcements and releases	il y a 3 years
	Would be nice to have a modifier available to block parts of... Dans le forum PrusaSlicer	il y a 4 years
	Any new Prusament PETG colours planned? Dans le forum General discussion, announcements and releases	il y a 4 years

Page 2 / 2 Précédent

Statistiques du forum

585 Forums

68.4 K Sujets

478.9 K Messages

12 En-ligne

76.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé