Prusa3D Forum

Notifications

Clear all

Hoppetee

Grupa: Zarejestrowany

Dołączył: 2024/03/16

Active Member

	Not sure if I should post this here - please excuse my ignor... In forum PrusaSlicer	8 months temu
	I can attest to that. Recently I tested small triangular "pi... In forum General discussion, announcements and releases	8 months temu
	Sigh... so much to learn...In retrospect, my result is obvio... In forum Hardware, firmware and software help	8 months temu
	Meanwhile, my question about how this part is incorrectly sl... In forum Hardware, firmware and software help	8 months temu
	Might be a matter of at which position of the cursor you let... In forum Hardware, firmware and software help	8 months temu
	Thanks for this clarification, Joan - might (should) come in... In forum Hardware, firmware and software help	8 months temu
	(Please excuse me for the long silence - I was unable to sit... In forum Hardware, firmware and software help	8 months temu
	Thin (1-2 mm heigth) object, first layers sliced as inverted... In forum Hardware, firmware and software help	9 months temu

Statystyki Forum

559 Fora

63.1 K Tematy

444 K Posty

22 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte