Prusa3D Forum

Notifications

Clear all

Hoppetee

Groupe: Enregistré

A(ont) rejoint: 2024/03/16

Active Member

	Not sure if I should post this here - please excuse my ignor... Dans le forum PrusaSlicer	il y a 11 months
	I can attest to that. Recently I tested small triangular "pi... Dans le forum General discussion, announcements and releases	il y a 11 months
	Sigh... so much to learn...In retrospect, my result is obvio... Dans le forum Hardware, firmware and software help	il y a 11 months
	Meanwhile, my question about how this part is incorrectly sl... Dans le forum Hardware, firmware and software help	il y a 11 months
	Might be a matter of at which position of the cursor you let... Dans le forum Hardware, firmware and software help	il y a 11 months
	Thanks for this clarification, Joan - might (should) come in... Dans le forum Hardware, firmware and software help	il y a 11 months
	(Please excuse me for the long silence - I was unable to sit... Dans le forum Hardware, firmware and software help	il y a 11 months
	Thin (1-2 mm heigth) object, first layers sliced as inverted... Dans le forum Hardware, firmware and software help	il y a 11 months

Statistiques du forum

565 Forums

64.2 K Sujets

449.6 K Messages

21 En-ligne

70.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé