Notifications
Clear all
HackMonkey
HackMonkey
Groupe: Enregistré
A(ont) rejoint: 2017/09/22
Trusted Member
3
Please bring back support for .30mm in Slic3r PE and Prusa C...

Dans le forum Others (Archive)

il y a 7 years
Slic3r PE has an option to show time? I have noticed that w...

Dans le forum Others (Archive)

il y a 7 years
Interesting...A clicking PSU just before the bed reaches tem...

Dans le forum Hardware, firmware and software help

il y a 7 years
Your not the only one. I think this is related to the issues...

Dans le forum Others (Archive)

il y a 7 years
David, is most likely the filament sensor. Blow it out with ...

Dans le forum Others (Archive)

il y a 7 years
No, just don't enable the port for the RPi in the settings u...

Dans le forum Others (Archive)

il y a 7 years
I am running the RC4 firmware and printing from the SD card....

Dans le forum Others (Archive)

il y a 7 years
Thank you for sharing this!!! Is this in the manual???? If...

Dans le forum General discussion, announcements and releases

il y a 7 years
The new slower unload in RC4 made things worse for me. Previ...

Dans le forum Others (Archive)

il y a 7 years
The power draw numbers I mentioned above were measured with ...

Dans le forum Others (Archive)

il y a 7 years
I don't have much interest in a touch screen. A good solid i...

Dans le forum General discussion, announcements and releases

il y a 7 years
I tied a couple small SMD LED panels directly into the power...

Dans le forum Others (Archive)

il y a 7 years
Thanks for jumping in Josef! Really appreciate all the teams...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 7 years
Loaded the new "Prusa Print" version of Octopi, much easier ...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 7 years
I was having a lot of issues with this when the sensor was o...

Dans le forum Others (Archive)

il y a 7 years
I figured out that turning on the auto load filament, remove...

Dans le forum Others (Archive)

il y a 7 years
I have been having lots of issues as well, mostly with Inlan...

Dans le forum Others (Archive)

il y a 7 years
Phew! I am glad I am not the only one that noticed this! I w...

Dans le forum Others (Archive)

il y a 7 years
Just looking at the power requirements listed on raspberrpi....

Dans le forum Others (Archive)

il y a 7 years
I installed the RC3 firmware yesterday, Octoprint is still h...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 7 years
Page 4 / 5
Partager :