Prusa3D Forum

Notifications

Clear all

GordonMcD

Grupa: Zarejestrowany

Dołączył: 2017/03/29

Active Member

	My solution, and I'm sticking to it, is to have a SD card de... In forum Hardware, firmware and software help	7 months temu
	I have resorted to keeping a clean SD card, with only my lat... In forum Hardware, firmware and software help	9 months temu
	Printer printing wrong g code file In forum Hardware, firmware and software help	1 year temu
	Thank you, I will check that next. In forum Hardware, firmware and software help	3 years temu
	LED Glitching In forum Hardware, firmware and software help	3 years temu
	I have the same issue. My ABS prints are failing at a very c... In forum Hardware, firmware and software help	7 years temu
	I had thermal runaway on a small piece that was centered on ... In forum Hardware, firmware and software help	7 years temu
	I have not seen it with the loaded g-codes. (I have printed ... In forum Others (Archive)	8 years temu
	Here is an example, attached, of its misbehavior. The 4" squ... In forum Others (Archive)	8 years temu
	Printer has its own ideas In forum Others (Archive)	8 years temu

Statystyki Forum

585 Fora

68.7 K Tematy

480.7 K Posty

13 Online

77.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte