Prusa3D Forum

Notifications

Clear all

GordonMcD

Skupina: Registrovaný

Přidal se: 2017/03/29

Active Member

	My solution, and I'm sticking to it, is to have a SD card de... In forum Hardware, firmware and software help	před 7 months
	I have resorted to keeping a clean SD card, with only my lat... In forum Hardware, firmware and software help	před 9 months
	Printer printing wrong g code file In forum Hardware, firmware and software help	před 1 year
	Thank you, I will check that next. In forum Hardware, firmware and software help	před 3 years
	LED Glitching In forum Hardware, firmware and software help	před 3 years
	I have the same issue. My ABS prints are failing at a very c... In forum Hardware, firmware and software help	před 7 years
	I had thermal runaway on a small piece that was centered on ... In forum Hardware, firmware and software help	před 7 years
	I have not seen it with the loaded g-codes. (I have printed ... In forum Others (Archive)	před 8 years
	Here is an example, attached, of its misbehavior. The 4" squ... In forum Others (Archive)	před 8 years
	Printer has its own ideas In forum Others (Archive)	před 8 years

Fórum Statistiky

585 Fóra

68.7 K Témata

480.7 K Příspěvky

9 Online

77.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed