Prusa3D Forum

Notifications

Clear all

GordonMcD

Group: Registered

Joined: 2017/03/29

Active Member

	My solution, and I'm sticking to it, is to have a SD card de... In forum Hardware, firmware and software help	5 months ago
	I have resorted to keeping a clean SD card, with only my lat... In forum Hardware, firmware and software help	8 months ago
	Printer printing wrong g code file In forum Hardware, firmware and software help	11 months ago
	Thank you, I will check that next. In forum Hardware, firmware and software help	3 years ago
	LED Glitching In forum Hardware, firmware and software help	3 years ago
	I have the same issue. My ABS prints are failing at a very c... In forum Hardware, firmware and software help	7 years ago
	I had thermal runaway on a small piece that was centered on ... In forum Hardware, firmware and software help	7 years ago
	I have not seen it with the loaded g-codes. (I have printed ... In forum Others (Archive)	8 years ago
	Here is an example, attached, of its misbehavior. The 4" squ... In forum Others (Archive)	8 years ago
	Printer has its own ideas In forum Others (Archive)	8 years ago

Forum Statistics

585 Forums

68.1 K Topics

477 K Posts

9 Online

75.8 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed