|
That describes it pretty well. I have learned to make a ment... In forum Hardware, firmware and software help |
4 days ago |
|
My solution, and I'm sticking to it, is to have a SD card de... In forum Hardware, firmware and software help |
11 months ago |
|
I have resorted to keeping a clean SD card, with only my lat... In forum Hardware, firmware and software help |
1 year ago |
|
Printer printing wrong g code file In forum Hardware, firmware and software help |
1 year ago |
|
Thank you, I will check that next. In forum Hardware, firmware and software help |
3 years ago |
|
LED Glitching In forum Hardware, firmware and software help |
3 years ago |
|
I have the same issue. My ABS prints are failing at a very c... In forum Hardware, firmware and software help |
8 years ago |
|
I had thermal runaway on a small piece that was centered on ... In forum Hardware, firmware and software help |
8 years ago |
|
I have not seen it with the loaded g-codes. (I have printed ... In forum Others (Archive) |
9 years ago |
|
Here is an example, attached, of its misbehavior. The 4" squ... In forum Others (Archive) |
9 years ago |
|
Printer has its own ideas In forum Others (Archive) |
9 years ago |
