|
Thanks, both of you. And looking very closely, I see that th... En el foro Hardware, firmware and software help |
hace 4 years |
|
"z leveling enforced" En el foro Hardware, firmware and software help |
hace 4 years |
|
Cold Pull Gone Wrong En el foro Hardware, firmware and software help |
hace 5 years |
|
Thank you for the advice - that was very helpful on a fundam... En el foro Hardware, firmware and software help |
hace 6 years |
|
Mesh Bed Leveling Fail En el foro Hardware, firmware and software help |
hace 6 years |
|
Oops - I see that I've posted this in the MK3 forum instead ... En el foro Hardware, firmware and software help |
hace 6 years |
|
Z Calibration Fail En el foro Hardware, firmware and software help |
hace 6 years |
|
But wouldn't whatever pulled he extruder out of whack have b... En el foro Others (Archive) |
hace 8 years |
|
That looks like the same problem, but maybe a different caus... En el foro Others (Archive) |
hace 8 years |
|
Thanks for the advice. Belts look good, and the bundle of ca... En el foro Others (Archive) |
hace 8 years |
|
Uh oh - not so fast. After switching to the Prusa edition of... En el foro Others (Archive) |
hace 8 years |
|
Thanks, everyone. It was the filament diameter setting in Cu... En el foro Others (Archive) |
hace 8 years |
|
I bought this printer assembled, so chances are that it's no... En el foro Others (Archive) |
hace 8 years |
|
Layer Offset Fail En el foro Others (Archive) |
hace 8 years |
