|
Thanks, both of you. And looking very closely, I see that th... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
"z leveling enforced" Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Cold Pull Gone Wrong Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Thank you for the advice - that was very helpful on a fundam... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Mesh Bed Leveling Fail Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Oops - I see that I've posted this in the MK3 forum instead ... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Z Calibration Fail Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
But wouldn't whatever pulled he extruder out of whack have b... Dans le forum Others (Archive) |
il y a 8 years |
|
That looks like the same problem, but maybe a different caus... Dans le forum Others (Archive) |
il y a 8 years |
|
Thanks for the advice. Belts look good, and the bundle of ca... Dans le forum Others (Archive) |
il y a 8 years |
|
Uh oh - not so fast. After switching to the Prusa edition of... Dans le forum Others (Archive) |
il y a 8 years |
|
Thanks, everyone. It was the filament diameter setting in Cu... Dans le forum Others (Archive) |
il y a 8 years |
|
I bought this printer assembled, so chances are that it's no... Dans le forum Others (Archive) |
il y a 8 years |
|
Layer Offset Fail Dans le forum Others (Archive) |
il y a 8 years |
